West Bend Electric Ice Shaver User's Guide download pdf (Page 7)

hen assembling, dismantling or cleaning, always ensure

that the appliance is switched off and is not connected to

the power supply.

Make sure that the GEAR RING is

pro

perl

y positi

oned

aro

und the exteri

or of the ICE AUGER.

Make sure that the ICE AUGER is placed inside the

SHAVER BOWL on the motor base and that the

SECURING NUT is properly locked in place.

Remove the LID by ﬁ rst pressing the RELEASE BUTTON

located on the back side of the MOTOR BASE, and then by

lifting up on the LID.

Place frozen ice cubes in the ICE AUGER leaving about

1 inch from the top level of the ICE AUGER. DO NOT

OVERFILL.

Place a wide mouth cup or snowcone under the ice outlet

to catch the shaved ice.

Lock the LID onto the MOTOR BASE by ﬁ rst engaging the

clips located on the front of the LID and the MOTOR BASE

and then by pressing the LID down onto the MOTOR BASE

while pressing the RELEASE BUTTON.

Plug unit into electrical outlet.

Press the ON/OFF button located on the back side of the

MOTOR BASE to begin making snow. DO NOT ADD ICE

CUBES THROUGH THE TOP OF THE UNIT WHILE THE

MACHINE IS RUNNING.

Once the unit has ﬁ nished shaving the ice cubes, press the

ON/OFF button again to turn the machine OFF. (After

shaving, there will always be a small amount of ice

remaining in the machine.)

Unplug from the power supply immediately after use.

OPERATION

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

West Bend Electric Ice Shaver User's Guide Page 7