West Bend Electric Hot Pot User Manual download pdf (Page 3)

• Do not use an outlet or extension cord if the plug fits loosely or if the outlet or

extension cord feels hot.

• For household use only.

SAVE THESE INSTRUCTIONS

EFORE

SING FOR THE

IRST

IME

Please check all packaging material carefully before discarding. Many

accessory parts are contained within the packaging material.

Before using, clean the entire appliance according to the cleaning instructions.

THIS APPLIANCE IS DESIGNED FOR HEATING WATER ONLY. DO NOT ADD

OTHER LIQUIDS OR FOOD TO HOT POT FOR HEATING PURPOSES AS A

BOIL-OVER CAN OCCUR.

SING

OUR

1. Remove cover by turning it counter-clockwise. Fill Hot Pot with

cold water to the desired cup level, using the 5½-ounce cup

markings on the inside of the pot as a guide. Do not heat less

than 2 or more than 5 cups of water at one time.

2. Place appliance on dry, level, heat-resistant surface, away from

any edge. Secure cover onto Hot Pot by aligning nubs on rim of

cover with notches in rim of pot. Turn clockwise. Cover will drop

slightly. Continue turning until cover is secured in place. Note

arrows on cover for correct turning direction. Care should still be

used when moving Hot Pot as the secured cover will not prevent

water from spilling if tipped over.

3. Plug cord into a 120 volt, AC electric outlet only. Allow water to heat until a boil

is reached. Two cups of water will be heated in about 4 minutes; 5 cups of water

in about 9 minutes.

4. After water is heated, with cover secured onto Hot Pot, pour water through spout

into a heat-resistant serving container. Water will remain serving hot as long as

pot is plugged into an electrical outlet. When less than 2 cups of water remain

in the pot, unplug cord from electrical outlet to prevent pot from boiling dry.

Remove cover from pot to determine amount of water left inside. If you wish to

heat additional water, unplug and empty water. Refill with cold water and follow

steps above.

• A small amount of smoke and/or odor may occur upon heating due to the

release of manufacturing oils – this is normal.

• Some minor expansion/contraction sounds may occur during heating and

cooling – this is normal.

1 2 3 4 5 6 7 8 ... 15 16

No comments

West Bend Electric Hot Pot User Manual Page 3